NS0-502 Online Practice Questions and Answers

Which utility on Windows 2003 and Windows 2008 can be used to collect information about firmware and driver versions for an Emulex LP1xxxx/LPe1xxx HBA?

A. EMutil

B. SANutil

C. fcp config

D. SANsurfer

E. HBAnywhere

Click the Exhibit button.

Given the information provided in the diagram, what is the appropriate FC topology?

A. point-to-point

B. switched fabric

C. arbitrated loop

D. ring

Which three protocols can be used for communications between a host running SnapDrive for Windows and the NetApp Storage Controllers? (Choose three.)

A. http:

B. https:

C. ftp:

D. RPC

E. ssh

When planning for fault tolerant power connections, how should each device to be connected?

A. with a single power feed

B. with dual power feeds

C. with dual power feeds connected to separate outlets

D. with dual power feeds connected to separate circuits

What should you do to verify FC connectivity between the host and the FC switch?

A. ping the FC switch Ethernet port from the host

B. check the FC switch for light on the FC port

C. check the FC switch for the WWPN of the host HBA

D. check the FC switch for the port type of the host port

What is NetApp's recommended best practice for zone configuration?

A. All zones should contain a single initiator and all the targets that initiator accesses.

B. Individual zones can get too complicated. It is better to simply configure one default zone with all devices contained in it.

C. All devices from the same vendor should be in one zone.

D. All zones should contain a single target and all the initiators using that target.

Which type of zoning does NetApp recommend?

A. World Wide Name zoning

B. World Wide Port Name zoning

C. World Wide Node Name zoning

D. Switch World Wide Name zoning

Which three tasks should be completed as part of the site preparation for install? (Choose three.)

A. plan zoning configuration

B. verify equipment move path

C. determine aggregate layout

D. verify power drops in the equipment location

E. make contact with data center personnel

Which software feature must be supported and configured on the NetApp storage controller to configure multipath high availability between the storage controller and disk shelves?

A. MetroCluster

B. Software Disk Ownership

C. Snapshot copies

D. Single System Image cfmode

When setting up a VLAN for administrative security purposes, which four ports are the only important ports to include in the VLAN? (Choose four.)

A. Storage Controllers Management Ethernet ports

B. FC Switches Ethernet port

C. Hosts iSCSI HBA Ethernet port

D. Ethernet Switches Management port

E. Storage Controller iSCSI Ethernet Target ports

F. Hosts NIC Ethernet port