NS0-184 Online Practice Questions and Answers

What should you do to change the data protocol of a LIF?

A. Delete and re-recreate the LIF.

B. Add the new data protocol to the LIF.

C. Put the LIF in another broadcast domain.

D. Shut down the assigned port.

You need to install a cluster with a FAS2720 HA pair and a FAS8300 HA pair.

Which NetApp tool will verify which cluster interconnect switches support this configuration?

A. Active IQ Config Advisor

B. Interoperability Matrix Tool (IMT)

C. Hardware Universe (HWU)

D. mysupport.netapp.com site

Click the Exhibit button.

You plan to install a new ONTAP cluster at a customer site by using the new ONTAP System Manager 9.7 GUI.

Referring to the exhibit, what must you do before you provision initial storage?

A. Configure cluster LIFs.

B. Configure protocols.

C. Configure a remote tier.

D. Configure aggregates.

Your customer wants a newly installed AFF C190 cluster to send SNMP notifications to a trap host called OVERWATCH01.

In this scenario, which two statements are correct? (Choose two.)

A. Configure an SNMP community string on the cluster.

B. Configure DNS on the cluster.

C. Configure a trap host on the cluster.

D. Configure a firewall policy and allow SNMP.

You are installing a new AFF A400 cluster that is running ONTAP 9.7 software. You are asked to attach an Amazon S3 cloud tier for FabricPool technology.

In this scenario, which two NetApp License File (NLF) types are supported for cloud tiering? (Choose two.)

A. term-based

B. perpetual

C. base

D. master

You want to ensure the highest path resilience and performance increase to the storage stack on your FAS8700 cluster.

In this scenario, which two types of stack cabling are available to use? (Choose two.)

A. quadpath HA

B. mixed-mode

C. single path

D. multipath HA

Click the Exhibit button.

You want to add a FAS2750 HA pair to an existing 6-node cluster.

Referring to the exhibit, which action would you perform to begin adding the node?

A. Use the back command to begin the Cluster Setup wizard.

B. Reboot the node and enter maintenance mode and run the Cluster Setup wizard.

C. Use the node setup wizard and select 0a as the management interface.

D. Use the exit or quit commands then run the cluster setup command.

After a system panic, the NetApp Support team advises you to run the sldiag command.

Which two actions must be performed before you use this command? (Choose two.)

A. At the LOADER prompt, type boot_maintenance.

B. At the storage system prompt, type halt.

C. At the LOADER prompt, type boot_diags.

D. At the storage system prompt, type boot_maintenance.

You are asked to add a new HA pair to an existing 2-node switchless AFF A220 cluster. You must first convert to a 2-node switched cluster using Broadcom BES-53248 cluster switches.

Which two conditions must be fulfilled before you start the migration? (Choose two.)

A. All cluster LIFs must be in the up state and on their home ports.

B. The "Enabled Switchless Cluster" option must be manually set to "false".

C. All cluster LIFs must have an MTU size of 1500.

D. The 2-node switchless configuration must be properly set up and functioning.

While testing a recently installed FAS8700 cluster, a node fails. You now need to replace the impaired node.

In this scenario, which two statements are true? (Choose two.)

A. You must move the boot device from the impaired node to the replacement node.

B. The boot device must remain intact and must not be removed from the impaired node.

C. You can change any drives or disk shelves as part of this replacement procedure.

D. A controller model of the same type must be used to replace the impaired node.