JN0-649 Online Practice Questions and Answers

Referring to the exhibit, ServerA sends a single IP packet destined to 10.0.0.127.

Which two statements correctly describe the behavior of the resulting outbound VXLAN packets that contain the original packet destined to 10.0.0.127? (Choosetwo.)

A. Router E will replicate and send a copy of the received VXLAN packet to router D.

B. Router C will send a VXLAN packet destined only to router D and router E.

C. Router D will not replicate and send a copy of the received VXLAN packet to routerE.

D. Router C will send a single VXLAN packet to one remote VTEP.

Remote branches connect to the corporate WAN through access switches. The access switches connect to access ports on the WAN distribution switch, as shown in the exhibit. L2PT has previously been configuredon the tunnel Layer 2 traffic across the WAN. You decide to move the L2PT tunnel endpoints to the access switches. When you apply the L2PT configuration to the access switches, the ports that connect the access switches to the distribution switch shut down.

Which action would solve this problem?

A. Configure the links between the access switches and the distribution switch as a trunk port.

B. Disable the BPDU block function on the access switches.

C. Disable the BPDU block function on thedistribution switch.

D. Configure a GRE tunnel to encapsulate the L2PT traffic across the WAN.

Referring to the exhibit, which LSA type is used toadvertise 192.168.1.0/24 to R5?

A. Type 5

B. Type 4

C. Type 3

D. Type 7

You are running OSPF as your IGP. The interfaces connecting two routers are in the ExStart state. You notice that something is incorrect with the configuration. Referring to the exhibit, which statement is correct?

A. The subnet mask is incorrect.

B. The MTU setting are incorrect.

C. The interface type is incorrect.

D. The IP addresses are incorrect.

You are troubleshooting a BGP connection.

Referring to the exhibit, which two statements are correct? (Choose two.)

A. Packetfragmentation is preventing the session from establishing.

B. The 192.168.1.5 peer has a misconfigured MD5 key.

C. The ge-0/0/1 interface is disabled.

D. The 192.168.1.4 peer has a misconfigured autonomous system number.

You are asked to implement fault tolerant RPs in your multicast network. Which two solutions would accomplish this behavior? (Choose two.)

A. Use BFD with statically defined RPs.

B. Use MSDP withstatically defined RPs.

C. Use anycast PIM with statically defined RPs.

D. Use IGMPv3 with statically defined RPs.

You are asked to configure 802.1X on your access ports to allow only a single device to authenticate. In this scenario, which configuration would you use?

A. single supplicant mode

B. multiple supplicant mode

C. single-secure supplicant mode

D. MAC authentication mode

You are using 802.1X authentication in your network to secure all ports. You have a printer that does not support 802.1X and you must ensure that traffic is allowed to and from this printer without authentication. In this scenario, what will satisfy the requirement?

A. MAC filtering

B. MACsec

C. static MAC bypass

D. MAC RADIUS

Referring to the exhibit, you haveplaced the cos multifield classifier on all edge interfaces and configured the relevant CoS parameters. In this scenario, which two statements are correct? (Choose two.)

A. SSH traffic using the default port will be placed in the af forwarding classand accepted.

B. SSH traffic using the default port will be placed in the best-effort forwarding class and accepted.

C. UDP traffic using the 16000 port will be placed in the voice forwarding class and accepted.

D. UDP traffic using the 16000 port will beplaced in the best-effort forwarding class and accepted.

There are two BGP routes to 10.200.200.0/24 received from twoexternal peers. Route 1 comes from a neighbor with a router ID of 10.10.100.1 and a peer IP address of 10.10.30.1, and route 2 comes from a neighbor with a router ID of

10.10.200.1 and a peer IP address of 10.10.50.1. Both routes have the same MED value, origin value, AS path length, and local preference number.

In this scenario, which statement is correct about the active route?

A. Route 1 will be active because of the peer IP address.

B. Route 2 will be active because of the peer IP address.

C. Route 1 will be active because of the router ID.

D. Route 2 will be active because of the router ID.