JN0-363 Online Practice Questions and Answers

Exhibit

Which two statements ate correct about the actions taken as the packet traverses the service provider MPLS network from Site 1 to Site 2 as shown in the exhibit? (Choose two.)

A. R2 will perform a lookup using the mpls.0 table.

B. R1 will perform a lookup using the lnet.3 table.

C. R1 will perform a lookup using the mpls.0 table.

D. R2 will perform a lookup using the inet.3 table.

The segment touting SRGB start label Is 10,000 and the SRGB index range is 500. In this scenario, which two statements are correct? (Choose two.)

A. The first usable label is 10,001.

B. The last usable label is 10.501.

C. The last usable label is 10,499.

D. The first usable label Is 10,000.

Which BGP message type is used to re-advertise routes that have already been sent to a peer and acknowledged using TCP?

A. update

B. keepalive

C. notification

D. refresh

Exhibit

Referring to the exhibit, which two statements are correct? (Choose two.)

A. Traffic ingressing ge-0/0/0 that is tagged with VLAN 101 will egress ge-0/0/1 unchanged.

B. Traffic ingressing ge-0/0/0 that is tagged will VLAN 100 will be dropped.

C. Traffic ingressing ge0/0/0 that Is tagged with VLAN 200 will egress ge-0/0/1 with an outer VLAN tag of 200.

D. Traffic ingressing ge-0/0/0 that is tagged with VLAN 101 will egress ge-0/0M with an outer VLAN tag of 200.

Which new field is added to an IPv6 header as compared to IPv4?

A. flow label

B. checksum

C. fragment offset

D. version

What is the correct order of BGP attributes for active route selection?

A. next hop -> local preference -> AS path -> MED -> origin

B. next hop -> AS path -> local preference -> origin -> MED

C. next hop -> local preference -> AS path -> origin -> MED

D. next hop -> origin -> local preference -> AS path -> MED

What Is a key differentiator of generate routes from aggregate routes?

A. Generate routes use a forwarding next hop.

B. Generate routes have a default next-hop value of reject.

C. Generate routes have a default preference value of 210.

D. Generate routes cannot be used as a gateway of last resort.

Which two statements are correct when using LDP? (Choose two.)

A. The lnet.3 table will contain only the paths explicitly defined.

B. The inet.3 table will contain a full mesh of label-switched paths to other LDP-enabled routers.

C. LDP label-switched paths are created by configuring LDP on at least one physical router interface.

D. LDP label-switched paths are created by configuring LDP on the loopbacK Interface.

What are two types of SlDs used in segment touting? (Choose two.)

A. node

B. adjacency

C. link

D. interface

Which two protocols are capable of distributing labels for segment routing? (Choose two.)

A. RSVP

B. LDP

C. IS-IS

D. OSPF