HPE6-A66 Online Practice Questions and Answers

Which two challenges do802.1ig barcode scanners present to a WLAN design? (Select two.)

A. roaming between APs

B. encountering RF interference by devices

C. determining the RF channel bandwidth consumed per Barcode scanner

D. implementing adequate security measures to ensure PCI compliance

E. providing consistent performance on all available channels

A network architect is designing a wireless solution for a company that is leasing one floor in a multi- floor building in a downtown area. The customer is concerned about ensuring complete Wi-Fi coverage and pin-pointing RF hazards.

What type of survey should the network architect perform?

A. Active

B. Virtual

C. Passive

D. Spectrum clearing

A network architect is redesigning a wireless network. The architect begins by analyzing the number of spatial streams supported by APs of various vendors as well as the wireless devices currently in the network, if the company wants to ensure that new wireless design, including user wireless devices, support Multi-User MIMO (MU-MIMO). Which standard or standards must the wireless products support?

A. Only 802.11ax and 8011.ac

B. Only 802.11ax

C. Only 802.11ax,802.1lac, and 802.l1n

D. Only 802.11ax,802.11ac, 802.11n, and 802.11a

A network architect has created two sites in IRIS and defined network devices for each site. From which window would a network architect connect the two sites together?

A. Topology

B. Site-1

C. Catalog

D. Start Page

A university department has a program in video processing and editing. Students in the department use Wi-Fi to interact with the video servers. The editing and processing is done by the students accessing and using the video servers. However, the students must then stream their results, via Wi- Fi to their laptops to verify the results. A network architect has determined that no more than 20 APs will be needed for the Wi-Fi solution. Because of the large amount of bandwidth used during the streaming, the Aruba mobility controller solution will need to support 10 Gbps links.

Which solution would cost-effectively meet this customer's requirements?

A. 7008

B. 7205

C. 7240XM

D. 7030

A high-end theater venue will be implementing an Aruba wireless solution using ceiling- and wall- mounted APs. The venue wants to ensure the the APs blend into the ceiling and wall environments. What solution should the customer use to ensure that wireless coverage is not hampered?

A. Place the APs above the ceiling and behind the walls

B. Place a strip of tape over the LEDs

C. Order Aruba AP covers for the APs

D. Paint the APs to match the ceilings or walls

A network architect needs to design a new wireless solution for a small company The architect estimates that about 150 APs will be required to implement a capacity design. Roaming support is required. Also, the design requires meshing to connect some of the APs to the network. The customer requires that client state synchronization be provided for real-time failover. Which solution would most cost-effectively meet these requirements?

A. lAPs in a cluster

B. FRAPs in a cluster

C. Two 7205 mobility controller and campus APs in a cluster

D. Two 7030 mobility controller and campus APs in a cluster

A customer requires Aruba switches that support Smart Rate ports to connect to Aruba APs.

Which switching product should the customer purchase that will provide 24 Smart Rate ports per access layer switch'?

A. OfficeConnect 1950

B. Aruba 2930F

C. Aruba 2930M

D. Aruba 2540

A network architect needs to plan a new wireless network:

A. Central only

B. Airwave and Central only

C. Airwave, Central, Windows, Mac OSX, and Linux

D. Airwave, Central, and Windows only

A company has hired a network architect to replace an existing legacy wireless and wired network The building is one-story and contains four wiring closets Based on the information the network architect gathered from the company, one 48port POE+ switch and three 48-port non-POE+ switches will be placed in each wiring closet. One stacking domain should be created for each wiring closet that supports 40 Gbps uplinks.

Which stacking solution should the architect implement for the floor that meets the requirements and is the most cost-effective'?

A. VSX

B. VSF

C. Backplane stacking

D. Distributed trunking