HP2-Z30 Online Practice Questions and Answers

What is the default username and password an administrator would use to log into a new HP MSM access point?

A. username of "hp" and password of "hp"

B. username of "msm" and password of "wireless"

C. username of "admin" and password of "hp"

D. username of "admin" and password of "admin"

Refer to the network exhibit.

Assume the network shown in the exhibit has implemented RSTP Based on the topology, which port is a root port?

A. SwrtchAport2

B. SwitchD port 1

C. SwitchC port 2

D. SwitchB port 1

Refer to the network exhibit.

All of the switches in the exhibit are configured as follows:

Config name =";Region!'

Revision #= 1

Instance 1=VLANs 10.12

lnstance2 = VLANs11,13

1ST instance = VLANs 1-9.14-4094

Currently, onlyVLANs 1,10,11,12, and 13 exist on the four switches. A network administrator adds VLAN 15 to Switch_C. How is the topology affected by this change?

A.

Spanning tree recalculates, with load sharing not in effect to Switch_C.

B.

Spanning tree recalculates, with load sharing still in effect to Switch_C.

C.

A loop now exits involving Switch_C.

D.

No topology changes occur with spanning tree.

Which HP Comware command saves the startup configuration file to a TFTP server?

A. startup

B. restore

C. backup

D. copy

Which command defines a default route on an HP Provision switch when routing has been enabled?

A. ip route 0.0.0.0/0 10.1.1.1

B. iP route 0.0.0.0/32 10.1.1.1

C. ip route 0.0.0.0 0 10.1.1.1

D. ip default-gateway 10.1.1.1

Refer to the partial command output:

Based on this output, which statement is true?

A. Dynamic LACP is used, and load sharing is functioning correctly.

B. Static LACP is used, and load sharing has failed.

C. Dynamic LACP is used, and load sharing has failed.

D. Static LACP is used, and load sharing is functioning correctly.

Which FlexArchitecture component uses Virtual Connect in blade server systems?

A. FlexFabric

B. FlexDataCenter

C. FlexManagement

D. FlexCampus

Which statement is true about the management of HP ProVision and Comware switches?

A. Telnet SSH are enabled by default on Comware switches.

B. Telnet is enabled but SSH is disabled on ProVision switches.

C. Comware switches, by default, store usernames and passwords in a separate configuration file.

D. ProVision switches, by default, store usernames and passwords in a separate configuration file.

Which Intelligent Management center (IMC) module implements policies for environments that support bringsyour own device (BYOD)?

A. NTA

B. SOM

C. EAM

D. UAM

Refer to the topology output.

Based on this topology, which statements are true? (Select two) A. The topology is functioning normally

B. This is a daisy chain topology

C. This is a ring topology

D. A break exists in the topology

E. There is a split stack