EW0-300 Online Practice Questions and Answers

Which CLI command configures DVMRP on all IP multicast interfaces.

A. config dvmrp add vlan all

B. config dvmrp add all

C. enable dvmrp

D. enable dvmrp vlan all

How many bits in the IP TOS field does a Summit 48i examine?

A. 4

B. 6

C. 8

D. 16

Dealing with access control lists on Extreme Networks switches it is not required to manually configure the default rule.

A. True

B. False

Which CLI command would you use to determine the IP routes that are tracked by ESRP?

A. show iproute

B. show esrp detail

C. show esrp config

D. Non of these

Limit-learning allows you to specify a maximum number of source MAC addresses per port/vlan. What happens when a number of dynamically learned MAC addresses time-out after the limit is reached?

A. That number of MAC addresses can be learned again.

B. No new MAC addresses are learned once the limit is reached.

C. The limit setting is only a threshold to generate an SNMP trap to the receiver.

D. New dynamically learned MAC addresses are queued until the administrator manuallyclears the counters.

A TCP type ACL that uses the permit-established keyword filters out SYN packets in one direction.

A. TRUE

B. FALSE

What mechanisms does a master node use to detect a failure in the EAPS ring architecture? Select the two that apply.

A. The master node receives a trap-message from a transit node when it detects loss oflink connectivity on any of its ring ports.

B. The master node uses OSPF to quickly learn about link state topology changes.

C. The master node sends a health-check packet on the control VLAN, when the ringbreaks the master node stops receiving this packet on its secondary port.

D. The master node uses IGMP and IGMP snooping to detect the transit nodes and thanto learn about failures in the topology between them.

Limit-learning and lock-learning cannot be combined on the same virtual port.

A. TRUE

B. FALSE

In SLB the forwarding mode is the method a switch uses to forward traffic to the virtual servers. On the Summit 7i switch four forwarding modes are supported, select the two forwarding modes that are hardware based.

A. Transparent mode

B. Translation mode

C. Port Translation mode

D. GoGo mode

In SLB a virtual server cannot belong to the same VLAN as the nodes in the referenced pool.

A. True

B. False