DES-DD23 Online Practice Questions and Answers

Which of the following protocols are supported by PowerProtect DD for data movement to a cloud provider?

A. CIFS and NFS

B. FTP and FTPS

C. VTL and DD Boost

D. HTTP and HTTPS

What can be used to monitor system utilization?

A. Health tab in the System Manager GUI

B. system show performance command

C. Alert Messages

D. system status command

An administrator recognizes poor network performance when using CIFS shares from a PowerProtect DD system. The network link utilization is under 100%.

What is the most likely cause of this issue?

A. TCP window size too small

B. TCP timeout too small

C. TCP timeout too large

D. TCP window size too large

Which command is used to start the initial CLI configuration wizard?

A. config setup

B. install config

C. config

D. setup

A backup administrator needs to implement BoostFS for Windows. What do they need to install on the Windows server?

A. NFS

B. FUSE

C. CIFS

D. CBFS

An organization uses tape libraries in their current backup infrastructure. They have purchased a PowerProtect DD system and plan to use VTL to move from physical tape. What is a consideration when configuring the tape size?

A. Use multiple drives to write multiple streams

B. Set retention periods for as long as possible

C. Target multiple drives to write single stream

D. Use larger tapes for multiple smaller datasets

An engineer is configuring a PowerProtect DD system for VTL using Fibre Channel. How should the zones be configured?

A. Hard zones

B. Single initiator, multi target

C. Single initiator, single target

D. Soft zones

An administrator has retained snapshots for a single MTree and is trying to create a new one. An error message is received. What is the reason for the failure?

A. The maximum number of snapshots has been exceeded

B. The user does not have the permission to retain more snapshots

C. There are not enough snapshot licenses

D. The DDOS needs to be upgraded

Which command is used to check if NFS is enabled?

A. nfs enable

B. nfs status

C. nfs show clients

D. system show

What is a requirement to use the PowerProtect DD HA feature?

A. Each head unit requires its own FS25 shelf

B. Head units and nodes require an active/active configuration

C. A single set of shared storage

D. Dual set of shared storage configuration