5V0-42.21 Online Practice Questions and Answers

Which port is used for the high availability connection between the two Edges on a pair of Edge 510s?

A. Any port may be chosen.

B. GE1

C. SFP1

D. GE4

A customer has a 10,000 branch site requirement arid must use a hub cluster in their design. Which Mware SO- WAN best practice should be used when designing the cluster?

A. BGP on WAN side

B. Static routing

C. MP BGP south bound

D. BGP on LAN side

A customer is using VMware vSphere in their data center. An administrator is asked to deploy SD- WAN Edges for a Proof of Concept as soon as possible. Which deployment option is the roost cost and time effective?

A. Deploy a virtual appliance on ESXi

B. Purchase bare metal Edge

C. Deploy a virtual appliance in AWS

D. Deploy a virtual appliance on KVM

Which three authentication mode options ate valid for use on the VMware SD-WAN Edge? (Choose three.)

A. Certificate Enabled

B. Certificate ate Optional

C. Certificate Disabled

D. Certificate Activated

E. Certificate Accepted

F. Certificate Requited

A VMware SD-WAN customer has a requirement to enable single sign-on (SSO) authentication to their

existing provider (idp) for access to their Orchestrator account.

Which authentication protocol is supported?

A. OpenID Connect (OlDC)

B. LDAP

C. SAML 2.0

D. TACACS+

An Enterprise customer just acquired a new company, and the Network Enterprise administrator was tasked to integrate over 20 new branches into their existing SD-WAN network. However, these branches have overlapping IPs with the existing branches subnets.

A. Configure a NAT hand off rule at the VMware SD WAN gateway assigned to these new blanches, translating the new branch subnets into a new nan-overlapping subnet

B. Configure a LAN-side NAT rule at the branch device settings, translating its subnets into a new non-overlapping subnet

C. Configure a NAT firewall rule in each branch, translating its subnets into a new non-overlapping subnet

D. Configure a policy based NAT tor each branch translating its subnets Into a new non-overlapping subnet

A customer is migrating a branch site with a VMware SD-WAN Edge coexisting with the CE. The Edge will be connected to internet link directly while connecting to the CE via a Layer 3 LAN switch. MPLS underlay is the preferred path for communication from this site to branch sites that have no VMware SD-WAN Edges. Communication from this site to branch sites that have VMware SD-WAN Edges should go through overlay.

A. Use BGP as the rout.ng protocol on UK Edge and flag its BGP neighbor to the Layer 3 LAN switch as Uplink.

B. Use BGP as the routing protocol on the Edge and filter prefixes from CE using Uplink Community

C. Use BGP as the routing protocol on the Edge and flag its HGP neighbor to PE as Uplink.

D. Use BGP as the routine, protocol on the Edge and flag its BGP neighbor to GE as Uplink.

What Is a typical use case for the deployment of a VMware SU-WAN Partner Gateway?

A. Provide connectivity between multiple enterprise customers over private circuits

B. Get improved flow analytics for all traffic in the SD-WAN network

C. Interconnect branches/remote sites of a single enterprise customer to the internet

D. Provide mite transport m a service provider backbone tor interconnecting a global customer SD- WAN branches.

Which VMware SD-WAN component Is responsible for overlay route distribution?

A. VMware SD-WAN Controller

B. VMware SD-WAN Orchestrator

C. VMware SD-WAN Edge

D. VMware SD-WAN Hub

Refer to the exhibit.

An MSP is designing a solution for a merger of Customer A and Customer B to Customer A's enterprise. Due to overlapping IP addresses and security requirements, the segments with the same names between Customer A and Customer A cannot be merged. Based on the graphic and the requirements, how many new segments need to be configured in the VMware SD-WAN Orchestrator?

A. 4 segments

B. 2 segments

C. 6 segments

D. 5 segments