156-836 Online Practice Questions and Answers

To display processes that are consuming excessive system resources, users should use the_____ command.

A. asg perf -v

B. asg stat -v

C. top

D. asg_perf_hogs

After you import the R81.10 software package, what do you use to verify that it is possible to upgrade an MHO or SG?

A. Run HCP. One of the tests will list upgrade eligibility status for the MHO or SG.

B. Run the Pre-Upgrade Verifier to make sure it is possible to upgrade

C. Nothing. CPUSE will run a verification during the upgrade process to ensure the package is compatible.

D. The package is verified during the import process and a warning or error will be displayed at that time.

The core four manual diagnostic tools include:

asg diag verify, asg perf -v, orch_stat -all, and

A. asg diag verify

B. cpinfo

C. hcp -r all

D. asg stat -v

During an upgrade, Is Multi-Version Clustering (MVC) supported?

A. No. Maestro does not support MVC because ClusterXL is disabled during an upgrade.

B. No, Maestro does not support MVC.

C. Maestro supports MVC or full connectivity upgrade as of R80.40.

D. Yes, MVC is supported as of R81 for Maestro.

Complete the sentence: Dual Orchestrators work as.______

A. Load Sharing cluster

B. Active-Active cluster

C. Active - Standby cluster

D. Hot-Swap RAID

How many orchestrators may Dual-Site include?

A. 2 or 4

B. 2

C. 1

D. Only 4

What will happen in case of NAT of the traffic passing through Management network?

A. This traffic will not pass correction, since it will be dropped

B. Orchestrator will disable NAT and traffic will pass with no issue

C. Since Management traffic is always going to SMO, it will take a care for Correction Layer and will re-distribute traffic to other Appliances

D. This traffic will pass with no inspection

There is a Security group of 10 Appliances and all of them are up and running. How many Appliances within a Security Group keep the same connection in its connection table in case of NAT?

A. Between 2 and 4

B. All 10

C. 2

D. 3

What kinds of transceivers are supported on Orchestrator MHO-140?

A. SFP, QSFP, QSFP28

B. SFP+, SFP28, QSFP

C. SFP, SFP+, SFP28

D. SFP, SFP+, QSFP, QSFP28

What cannot be a reason for "Failed to get remote orchestrator interfaces" error message, when clicking on "Orchestrator" in WebUI

A. Remote orchestrator has no empty interfaces

B. Single orchestrator environment, but configured Orchestrator amount is 2

C. One orchestrator only, but Orchestrator amount is 2 or no Sync in between orchestrators

D. No Sync between orchestrators