101-01 Online Practice Questions and Answers
What is the default action of a Steelhead appliance when it enters admission control?
A. Fail-to-wire
B. Fail-to-block
C. Passthrough all connections
D. Passthrough new connections
E. Drop new connections
How many separate TCP sessions exist for each optimized connection?
A. 1
B. 2
C. 3
D. 4
E. It depends on the WAN visibility mode
What is the command to clear all statistics on a Steelhead appliance?
A. (config) # stats clear-all
B. (config) # clear-all stats
C. (config) # reset stats
D. (config) # reload stats clean
E. (config) # clear stats
In a network where QoS classification and enforcement is being performed by the customer's carrier-managed WAN routers and QoS traffic classification is based on IP address and/or destination TCP port, what WAN visibility mode should be employed for TCP sessions optimized by the Steelhead appliances to maintain interoperability with the existing QoS strategy?
A. Full Transparency
B. Correct Addressing
C. Port Transparency
D. Port Mapping
Steelhead appliance models vary according to which of the following attributes?
1.
Number of concurrent TCP connections that can be optimized
2.
Amount of disk storage available for Scalable Data Referencing
3.
Level of encryption supported
4.
Maximum possible in-path interfaces
A. 1, 2, and 3
B. 1, 2, and 4
C. 2, 3, and 4
D. 1, 3, and 4
E. 1, 2, 3, and 4
When configuring the Steelhead Mobile client package, the amount of disk space allocated to the datastore for a Steelhead Mobile client is configured in what part of the configuration?
A. Endpoint policy
B. Authentication policy
C. Acceleration policy
D. Peering policy
What is the remote port used for on a Riverbed hardware appliance?
A. Remote control using a modem or ISDN device
B. IPMI "lights out" Remote control management
C. Export of netflow statistics
D. SteelFusion Edge device connection
E. Data store synchronization
What is the CLI command for starting the Configuration Wizard?
A. # configuration wizard start
B. (config) # configuration jump-start
C. # configuration start
D. (config) # wizard start
E. restart clean
Which report would you use to monitor disk utilization in the SteelHead management console user interface?
A. Reports > Data Store Cost
B. Reports > Data Store Disk Load
C. Reports > Data Store Hit Rate
D. Reports > Data Store Status
What basic configuration steps should be done on the SteelHead before attempting to join it to a Windows Domain? (Choose two.)
A. Configure either a Delegation or Replication user.
B. Configure DNS to include an entry for resolution of the SteelHead primary interface IP address.
C. Enable SMB signing/Encrypted MAPI support.
D. Ensble NTP and ensure time is synced with domain controllers.
All rights are reserved by
leads4pass.com. Any changes, copy or trademarks abuse will be
regarded as infringement.
leads4pass.com will reserve the right to pursue accountability.
Copyright © 2004-
2026 leads4pass.com.